Article ID: 20130513
1. To change time or custom settings, download the configuration tool from Support - Download
2. For Z11 / Z12 / Z15 / Z16/ Z18 / ZIR32: Install and run the "Zetta Widget"from "Start"->"Program"->"Zetta"->"Zetta Widget" for Windows, or "Launchpad" for Mac
   For Z82 / Z86:  Install and run the "Camera Widget" from "Start"->"Program"->"Camera"->"Camera Widget" for Windows, or "Launchpad" for Mac
3. Put a microSD card into the DVR and plug the DVR to the computer
4. To change time, press "Sync Date Time to DVR"
5. To change settings, in "Option" page, change to "Custom Mode", then press "Save Option"
6. In "Settings" page, adjust the settings you want, then press "Sync Settings to DVR"
7. Put the slide switch of the DVR to the right before powering up. The DVR will record according to the computer settings
8. If trigger is enabled, the DVR will first record for 10 seconds. Then it will standby if there is no trigger
9. If there is trigger, it will record and record until no further triggers, and keep recording for 5 more minutes and then standby

Copyright © All rights reserved.